Once and Future
2011-09-24 20:52:43
Sorry Bearhair, I don't have an answer for you. But I have a question of my own. I see in your picture you have some of the same brass-looking hydraulic fittings on non-conductive hose like I have on my boat. They are great because even after years of exposure to salt spray, they still come apart.
So I am asking if you, or anyone else, knows where I can still buy that kind of fitting? I haven't tried to disassemble a fitting yet, but they even look field-repairable, which would obviously make them even greater!
I also see the Robertson (square drive) screw in the photo, which leads me to believe your boat was Canadian at one time, just like mine. As a further clue to you, my boat also came with the same diverter valves on it. So maybe these valves have a Canadian source.
(Incidentally, square drive screws are damn good too. I saw on a show on why we don't have them in the states. Henry Ford was using them in his early cars. Being the hard-baller that he was, he insisted he would no longer buy the screws from the Canadian manufacturer and they must sell him the company. The owner refused. Ford switched to the phillips head. And that is why we Americans have been stripping screws ever since.)
lone eagle
2011-09-24 23:49:45
I've been doing construction on and off for a few years and using square head stainless wood screws, made by Swaneze.
bearhair
2011-10-18 19:03:49
Hello Once and Future,
not sure about a source for the hose fittings. The shop I get to make up my hoses has no trouble finding the brass fittings. You are correct that my boat is a Canadian boat, robertson screws and all!
Sure wish I could find a brass diverter valve as I've looked and asked around everywhere and can only find cast iron ones.
Stephen
Hotspott
2011-10-27 04:38:04
Have a brass lever valve if you are still interested. PM me.
bearhair
2011-10-28 20:26:34
PM sent
